Roland - BT-12 Cleaning the Internal Ink System
Introduction
Cleaning your machine's internal ink components is crucial to maintaining optimal performance and prolonging its life, especially if it has not been used for an extended period. Follow these steps to ensure a thorough internal cleaning.
You will need 4 Cleaning Cartridges corresponding to each ink color
- BT-CC-BK
- BT-CC-CY
- BT-CC-MG
- BT-CC-YE
Cleaning cartridges are for single use. Do not reuse them, even if liquid remains inside, as it may result in incomplete cleaning.
Steps to Clean the Internals
Prepare the Machine
- Turn the machine on and ensure it is in the "Ready" state.
- Confirm that the ink collector unit has sufficient capacity. Replace it with a new ink collector unit if it is almost full or full.
Access the Maintenance Menu
Select Clean Internals
Insert the Cleaning Cartridge
Start the Cleaning Process
Press the [▲]
or [▼/Menu]
key to display [Execute]
, and press the [#Enter]
key.
Press the [#Enter]
key again to start cleaning.
- The cleaning process will take approximately 16 minutes. Wait while "Maintenance in process..." is displayed.
Finish the cleaning
- When "Cleaning finish Restart machine" is displayed, hold down the
[Power]
key to turn off the power. - Replace the ink cartridge, turn the machine back on, and provide the initial ink supply.
- Wait until the message "Ready" appears after the initial ink supply is provided.
Warnings and Precautions
- Do Not Interrupt: Do not cancel the cleaning process once it has started. The cleaning must be completed before the machine can be used again.
- Waste Fluid: Cleaning the interior generates a lot of waste fluid. Ensure the ink collector unit has enough capacity to hold it.
- Single-use cartridges: Cleaning cartridges are for single use. Do not reuse them, even if liquid remains inside, as it may result in incomplete cleaning.
- Storage: Keep a cleaning cartridge attached to store the machine after cleaning. When using the machine again, replace the cleaning cartridge with a new ink cartridge.
Troubleshooting
- Failed Cleaning: If cleaning fails, follow the displayed instructions to resolve the issue. Common solutions include resetting or replacing the cleaning cartridge, ensuring the right front cover is closed, and raising the room temperature if necessary.
- Error Messages: If error messages like "Open Front Cover / Reset Cartridge" or "Prepare new Ink Collector Unit" appear, take the appropriate actions to resolve them before attempting to clean again.
Following these steps will help ensure your machine's internal components are properly cleaned, maintaining its performance and extending its operational life .