Formlabs - Form Wash/Form Wash L Time Settings

Formlabs - Form Wash/Form Wash L Time Settings

The Form Wash/Form Wash L removes uncured resin from the surface of printed parts by simultaneously soaking and moving them in a solvent. The Form Wash/Form Wash L can be used with isopropyl alcohol (IPA) or tripropylene glycol monomethyl ether (TPM).
The table below indicates the recommended times to wash parts printed in Formlabs resins using the Form Wash/Form Wash L. Formlabs updates wash settings periodically with new and improved materials.
​







    • Related Articles

    • Formlabs - Form Cure Time and Temperature Settings

      The Form Cure helps 3D-printed parts achieve their highest possible strength and stability. Optimal post-curing settings depend on the equipment and the part's geometry. Select the material type and version below to see the recommended Form Cure time ...

    • Formlabs - Form 3 Level Sensor Error

      The LevelSense board is located directly behind the resin tank. It senses the position of a metal float in the resin tank to determine the amount of resin in the resin tank. The printer may display Resin Level Sensor Error if there is an issue with ...