Epilog - Vector Lines are Not Being Spilt by The Dashboard

1. Ensure vector line weights are set properly: 

1. Hairline - Corel Draw
   
2. .001 - Adobe Illustrator
   

2. Epilog Dashboard Settings May Not Be Configured Properly: 

1. Open the Epilog Dashboard 
   
2. Click the settings gear In the upper right-hand corner. 
   
3.  Navigate to the Dashboard Tab.
   
4. New Job Settings Should Be Set to Split by Hairlines
   
5. Close the Dashboard and Resend the Job.
   

3. If this Issue Persists in Adobe Illustrator with images on the artboard, see here: Epilog - Adobe Illustrator Images and Vector Cut Lines Ignored

• Related Articles

• Epilog - Adobe Illustrator Images and Vector Cut Lines Ignored

  Issue: Adobe Illustrator: Certain Images wipe out vector hairlines when printed to the epilog driver. The vector lines are treated as engravings when they make it into the epilog print driver. Something in the image source file seems to cause the ...

• Epilog - Fusion Maker - Fusion Edge - Fusion Pro 24 & 36 Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instuctions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak in ...

• Epilog - Mini, Helix Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

• Epilog - Zing 16 Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

• Epilog - Zing 24 Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...