Epilog Helix - System LCD error = Sys PleaseR or Please Reboot.
It could be a controller or laser tube.
- Turn off the machine and unplug the ethernet connector on the laser tube. Then reboot. If the error still exists with the tube ethernet disconnected, the controller needs to be replaced.
- Turn off machine and unplug ethernet connector on the laser tube. Then reboot. If the error goes away with tube ethernet disconnected, the tube needs replaced. Or you can try to blow out connector with compressed air and reseat. This may fix the issue without replacing the tube. Otherwise the tube will need replaced.
Related Articles
Epilog - Fusion Maker - Fusion Edge - Fusion Pro 24 & 36 Alignment
CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instuctions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak in ...
Epilog - Mini, Helix Laser Alignment
CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...
Epilog - Adjusting Table Level for the Mini and Helix
Ensuring a perfectly level table is not just a step, but a crucial prerequisite for any cutting or engraving project. In this guide, we'll walk you through the process of checking your table level and making adjustments as necessary. Checking the ...
Epilog - Corel Draw Settings for Photo Engraving on Wood
Open your photo in CorelDRAW, then resize and crop it to the final size you want to engrave. Note: In the final step of this process, it’s very important not to change the size of your photo once you convert it to a black-and-white 1-bit photo. With ...
Epilog - Fusion M2 Laser Alignment
CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...