Epilog - Cleaning the X-Axis Linear Encoder

Issue: 

If you are seeing wavy engraving, or the engraving seems to be drifting across the page, you probably have a dirty linear encoder. Cleaning is a quick process that we will explain below.

Solution: 

Before you begin the steps for cleaning your x-axis linear encoder strip, you'll need a few tools:

• Phillips head screwdriver
• Distilled water
• Cotton swabs
• Can of compressed air (optional)
  

Step 1:

There are seven screws that attach the x-axis linear guide cover: two on the front side and five on the back. Unscrew each of the screws until each one is loose enough to remove the linear guide cover

You will not need to remove all of the screws to remove the cover completely.

The linear encoder strip is the clear plastic strip that runs along the width of the x-axis beam pictured above.

Step 2:

Using the cotton swab dipped in distilled water, wipe the cotton swab along the front and back side of the linear encoder strip to remove any smoke or dust debris that might have collected on the strip.

Once you've finished wiping down each side of the encoder strip, go back with a dry cotton swab and wipe away any moisture that might have been left behind.

  

Step 3: 

Now place the linear guide cover back onto the x-axis beam using the partially unscrewed screws as a guide. Tighten the front screws first, followed by the back screws last.

Conclusion: 

And now you're finished! How often you'll need to clean your linear encoder strip will depend primarily on what type of materials you are engraving and cutting.

• Related Articles

• Epilog - Fusion Maker - Fusion Edge - Fusion Pro 24 & 36 Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instuctions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak in ...

• Epilog - Mini, Helix Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

• Epilog - Fusion M2 Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

• Epilog - Zing 16 Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

• Epilog - Zing 24 Laser Alignment

  CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...