Epilog - Fusion Maker - Fusion Edge - Fusion Pro 24 & 36 Alignment

Epilog - Fusion Maker - Fusion Edge - Fusion Pro 24 & 36 Alignment

CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally.

Download the Attached PDF for Detailed Instuctions. 

Complete this procedure if any of the following behaviors are observed:
  1. Laser power appears weak in certain areas of the table, especially when moving from left to right in the engraver.
  2. The engraver cannot effectively cut through materials at or around the recommended settings.
  3.  Optics in the lens assembly fail prematurely.
  4.  If the engraver has been moved to a new location

Or if any of these components have been replaced:

  1.  Laser tube
  2. Mirror #1, #2, or #3
  3. X-axis assembly
  4. Red dot diode


    • Related Articles

    • Epilog - Fusion M2 Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

    • Epilog - Fusion Pro 32 & 48 Leveling the Table

      Download the Attached Document for Detailed Instructions: Table level should be checked periodically to ensure that all areas of the table are the same distance from the focusing lens. If all areas of the table are not the same distance from the ...

    • Epilog - Mini, Helix Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

    • Epilog - Zing 16 Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

    • Epilog - Zing 24 Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...